english:

 

                                 

 

3.2.8 To Run or Not to Run ‑ That is the Question

     Because of the improved error handling and the "defensive programming" that has been employed in the design of the ISC model, it is intended that the model will read through all of the inputs in the runstream file regardless of any errors or warnings that may be encountered.  If a fatal error occurs in processing of the runstream information, then further model calculations will be aborted.  Otherwise, the model will attempt to run.  Because of the great many options available in the ISC models, and the potential for wasted resources if a large run is performed with some incorrect input data, the RUNORNOT keyword has been included on the Control pathway to allow the user to specify whether to RUN the model and perform all of the calculations, or NOT to run and only process the input runstream data and summarize the setup information.  The syntax and type of the RUNORNOT keyword are summarized below:

Syntax:

CO RUNORNOT  RUN or NOT

Type:

Mandatory, Non‑repeatable

3.2.9 Generating an Input File for the Short Term EVENT Model

     The Short Term model consists of two executable files ‑ one is used for routine processing (ISCST) and the other is used for EVENT processing (ISCEV).  The EVENTFIL keyword controls whether or not the ISCST model will generate an input file for use with the EVENT model, and applies only to the ISCST model.  The syntax and type of the EVENTFIL keyword are summarized below:

Syntax:

CO EVENTFIL  (Evfile)  (Evopt)

Type:

Optional, Non‑repeatable

where the optional Evfile parameter specifies the name of the EVENT input file to be generated (up to 40 characters), and the optional parameter, Evopt, specifies the level of detail to be used in the EVENT output file.  Valid inputs for the Evopt parameter are the secondary keywords of SOCONT and DETAIL (see  the EVENTOUT keyword on the OUtput pathway, Section 3.7.2).  The default filename used if no parameters are specified is PASSTWO.INP, and the default for the level of detail is DETAIL.  If only one parameter is present, then it is taken to be the Evfile, and the default will be used for Evopt.

 

151 - 152 - 153 - 154 - 155 - 156 - 157 - 158 - 159 - 160 - 161 - 162 - 163 - 164 - 165 - 166 - 167 - 168 - 169 - 170 - 171 - 172 - 173 - 174 - 175 - 176 - 177 - 178 - 179 - 180 - 181 - 182 - 183 - 184 - 185 - 186 - 187 - 188 - 189 - 190 - 191 - 192 - 193 - 194 - 195 - 196 - 197 - 198 - 199 - 200

 

 

 

     Flag of Portugal 

 castellano:     italiano:     

 

 français:    português:  

 

deutsch:

 

castellano: DIS CUS DES  RAD   english: DIS CUS DES RAD  

 

 português: DIS CUS DES RAD   italiano:   DIS CUS  DES RAD

 

français:  DIS CUS DES RAD