english:

 

 

                                 

 

 

2.5.2 Adding or Modifying a Source or Source Group

     Modifying the input file to add a source or a source group, or to add a source to a source group, is as simple as just adding it.  There is no need to specify the total number of sources in the run, which would then have to be changed if more sources were added.  The same applies to the number of groups, or the number of sources per group.  If the user attempts to input more than the total number of sources or groups allowed for a particular run, an error message will be generated to that effect.  Also, modifying a source group to  delete a source is as easy as just deleting it from the input card, without having to change any other inputs.

     Another way of "deleting" a source or a group from an input file is to place a "**" in the pathway field of the card or cards which define the source or group to "comment out" those inputs.  This approach, which was discussed above in Section 2.1.2, has the advantage of leaving the input data for the source or group in the input file for possible later use. It doesn't matter whether the "**" is entered with the text editor in "insert" mode, in which case the other inputs of that line are moved over, or if it is in "overtype" mode, which would replace the pathway ID that was already there.

 

151 - 152 - 153 - 154 - 155 - 156 - 157 - 158 - 159 - 160 - 161 - 162 - 163 - 164 - 165 - 166 - 167 - 168 - 169 - 170 - 171 - 172 - 173 - 174 - 175 - 176 - 177 - 178 - 179 - 180 - 181 - 182 - 183 - 184 - 185 - 186 - 187 - 188 - 189 - 190 - 191 - 192 - 193 - 194 - 195 - 196 - 197 - 198 - 199 - 200

 

 

     Flag of Portugal 

 

 castellano:     italiano:     

 

 français:    português:  

 

deutsch:

 

  APLICACIONES castellano: DIS CUS DES  RAD   english: DIS CUS DES RAD  

 

 português: DIS CUS DES RAD   italiano:   DIS CUS  DES RAD

 

français:  DIS CUS DES RAD